How to install Appeck Permanent Outdoor Lights Pro

Installation Steps：

1 .Before installation, please connect each string light first and then plug it into power to make sureevery string light can work prpedy.

2.Detemmine the location of the first light string. Make sure the adapter and control box are longenough to connect to the power supply. Secure the adapter to the wall to hold the bottom ofthelight string.

3.Prepare a ladder and make sure it is stable enough or use it with thehelp of another person.

4. Wipe the surface where you plan to install the string oflights with a cloth or paper towel.Make sure the surface is clean and dry. lt is recommended to mount the light stringvertically 5-10 cm fom the wall.

5.Tear offthe VHB adhesive from the back of lights, then firmly press the light againstthe surface for more than 5 seconds.

6.For long temm use, use serew clips to securely fsten the string oflights to the eaves

7 .Pluginto power and start to enjoy the colorful lighting effects.

Usage of Wire Connector：

Product Size：

 Troubleshooting

1. Light doesn't glow at all / Some lights do not glow.

If only the first strip glows while the power adapter is plugged in, unplug the power adapter and plug it in again.
If some lights don't glow, disconnect all components and reconnect all components and plug the power adapter in again, or press the control unit to detect the light.
If any of the selected light effect are not fully displayed, contact Appeck support team for further analysis or product replacement.

2. Cannot connect to Wi-Fi.

The 5GHz network is not supported. Please set the router to 2.4GHz and then reset it.
Do not skip the Wi-Fi connection steps in the app.
Make sure you have entered the correct Wi-Fi name and password.
Connect the hotspot of your phone to the product.

3. Adhesive stickers don't stick.

Clean the surface with a cloth and make sure there is no residue.
Remove the original sticker and replace it with the replacement stickers.
Make sure to press against the surface for at least 5 seconds when installing the light.
Use screws for reinforcement.
Important Safety Instructions

 Important Safety Instructions

• This product is rated as IP67 waterproof.The power adapter is rated as IP67 waterproof and can be immersed in water.
• To prevent the light strip from falling down, make sure to secure it with both the 3M adhesive tape and the screws.
• Tighten up the waterproof cap before using the light.
  
• Do not allow children to assemble or install this product.
•  Avoid installing this product near large heat sources or other dangerous sources.
• The recommended temperature range for devices and accessories is --4°F to 140°F.
• Unless specifically indicated that it is safe to do so in the user guide or instruction manual, do not use this device in an environment that exceeds the recommended low or high temperature.
• Unless specifically indicated that it is safe to do so in the user guide or instruction manual, avoid exposing your device to direct sunshine or excessively wet environments.
• For pluggable equipment, the socket outlet should be easily accessible.
• Use only the adapter provided by the manufacturer. Using unauthorized adapters may cause danger and violate the authorized use of the device or the warranty article.